*HITEC WILL BE CLOSED 5/27/24 TO OBSERVE MEMORIAL DAY*

Customer Service: M-F/ 8a-4:30p PST

(858) 748-6948 service@hitecrcd.com
(858) 748-6948 service@hitecrcd.com

Receivers

Super Slim

Q. What types of planes should I use the Super Slim in?

A. The Super Slim receiver can be used in any type of Aircraft though it was originally designed for electrics and sailplanes.

Q. How long should the antenna be?

A. The antenna is 42 inches (1050mm). If you are replacing the antenna, make sure to use a multi-strand wire of about 28 gauge.

Q. What crystal does the Super Slim use?

A. The Super Slim uses a dual conversion crystal. The part number is 66772xx (xx= channel number). To tell if your crystal is dual conversion or not, examine the pull tab. If the tab has blue end and the letters 'RF' on it, then it is a genuine Hitec dual conversion crystal. Use only genuine Hitec crystals in the Super Slim or it will have decreased range.

Q. What transmitter will the Super Slim work with?

A. The Super Slim is available in three different configurations. The 29272 (negative shift) is for Futaba and Hitec transmitters when using Futaba 'J' servos. The 29572 (negative shift) is for Hitec and Futaba transmitters when using Hitec 'S' servos. The 29672 (positive shift) is for Airtronics and JR transmitters when using Airt 'Z' and JR style servos.

Q. Which way do the servos plug in?

A. Looking at the top of the receiver, with the servos plugs on the right hand side and starting from the top pin down, it is signal, positive and negative.

Q. What are the channel assignments?

A. Channel assignments are set by the transmitter being used. In the case of Hitec, channel 1 is ailerons, channel 2 is elevator, channel 3 is throttle and channel 4 is rudder.

Q. Where can I plug the receiver battery?

A. The battery can be plugged into any available slot.

Q. I have an ESC, which channel do I plug it into?

A. If you are using an ESC with a Hitec transmitter, plug it into the throttle channel (ch 3).